Robot Vacuum Cleaner iRobot 730/790 Series ..

This robot vacuum works on its own, with a charged battery, starting at the base where it returns at the end of the job to recharge.

Before cleaning, it is necessary to clear the floor of any small objects that may be present and remove any cables. It's also good to avoid running it when there are liquids on the floor that could cause the wheels to slip and the brushes to get wet.

Roomba can also run without a base, start on its own, complete the cleaning cycle and turn itself off when finished.

Operation is simple:

Press CLEAN once to turn the device on.

A beep will sound and the CLEAN button will light up.

- Press CLEAN again to start a cleaning cycle.

- When on Home Base, simply press CLEAN.

- To pause the device during the cleaning cycle, press CLEAN.

- To resume the cleaning cycle, press CLEAN again.

- To turn the device off, press and hold the CLEAN button until the lights go out.

Full cycle cleaning room : from 30 ' to 55' (depends on the amount of dirt)

Standard charging base. Programming: daily or weekly.

Ordinary maintenance

To clean the side brush use a small Phillips screwdriver to remove the screw from the center. Remove the brush, clean it and also clean the white pin on which hair and dust can get tangled, Reinstall the side brush.

Empty the dust container and clean the 2 filters.

Cleaning the brushes 

• Remove the brush guard by lifting both yellow tabs.
• Remove and clean the two brushes and bearings.

Cleaning the front wheel

• Pull firmly on the front wheel housing to remove it.
• Remove debris from the wheel cavity.

• Remove the wheel from its housing and clean it. Pull firmly to remove the axle and remove any twisted hairs around it.

• Once finished, reinstall all parts.
• Make sure the wheel is reinstalled correctly.

The video will explain how to do it.